Unipolar wire contact installation instructions
Before installing the trolley wire, first fix the angle bracket according to the installation type selected by the user, and fix it according to the hanging distance of the trolley wire. Put the required suspension seat on the slip wire of every 6 meters at the installation site, and One end of each end connector jacket, and one end is equipped with an aluminum connector. When installing the aluminum connector, it is necessary to pay attention that only the aluminum rail can be inserted into the joint 1/2 and left to connect with another rail. After the above work is ready, Then suspend one by one wire on the bracket for full-line connection. When connecting, tighten the screws of each connector. When the total length of the trolley line exceeds 200 meters, a telescopic device (television equipment supplied at any time) should be installed. When the power cable is connected, it can be connected at every 6 meters of joint. The specific connection method can refer to the front Connector device diagram.
When installing a curved trolley line, the suspension distance should be shortened accordingly. The specific dimensions can be determined according to site conditions.
When installing the conductive device, the conductive device is first installed on the matching square tube, and the appropriate position matched with the trolley line is selected to be fixed on the electrical equipment. Care should be taken to ensure that the conductive device and the trolley line have good tracking performance. With good contact ability, the conductor and trolley wire should be installed in the same vertical and horizontal direction.
Pumps For Sewage Trearment
Acid Transfer Pump,Pumps For Sewage Trearment,Sewage Pumps With Propeller,Horizontal Sewage Water Pump
Sichuan Zigong Industrial Pump Co.,Ltd. , https://www.zgpump-global.com