The method for changing tires is very simple. I don’t believe you know it.

Tyres are the most vulnerable parts of a car, and not to mention a puncture can lead to serious accidents, even if a leak in a small hole is enough to go wrong. Recently, a netizen complained to the small i (micro-signal: dycwesc) that the car tires suddenly leaked during business trips. Since he would not operate, the delay would be long and the business would be lost.
Tire leakage , 99% of the tread is a hole, nails, screws and other foreign bodies, how to do? Replace the spare tire! Yes! But the tires are also a technical live, the old driver may have been light truck, for novice In terms of it, it may not even know where the top dollar is, let alone change the tire. The following small i (micro signal: dycwesc) will teach you how to get your own tires.

    What happened when the tire leaked halfway?
1. Immediately stop the car on a level road and not affect the safety of the traffic. Turn on the hazard warning flash and turn off the parking brake. In the distance from the rear 50m outside the safety warning sign, if it is high-speed road to be placed in the rear 150m.

    2. Take out the spare tire from underneath the trunk floor. Most of the spare tires in the SUV (private area) models are hung under the rear of the vehicle or fixed outside the trunk door.
     3, remove the tires, first with a socket wrench to loosen the tire fixing screws, loosen the bolts, the method should be used to loosen the diagonal one by one, this is to prevent fasteners from uneven force and deformation.

4. Both sides of the vehicle have slots for placing jacks on both sides. Be sure to place the jacks in the slots, and then slowly continue upwards until the flat tire can be removed. After the jacks are lifted, unscrew the loosened screws and remove the smashed tires.

    5. Install the spare tire, tighten the tire nut in the diagonal position, then twist it all at once, tighten it slightly with a wrench, loosen the jack, put down the car, pull out the jack, and tighten the screw again with the opposite corner of the wrench. Twist 1/4 of the full circle and repeat 2 to 3 times.
The question is, what if the tire is punctured without a spare tire?
Four emergency handling tips:
1, fetal patch

    The tire-tightening agent can both repair the tire and inflate it. When the tire is punctured and leaks out, as long as the puncture sealant is connected to the top of the tire and the puncture sealer valve is pressed, the compressed air is automatically added to the tire, and a white tire sealant is injected at the same time. Can be on the road. However, if the vulnerability is greater than 6mm, it cannot be remedied.
2, hit the gun


The shot is made by inserting special rubber strips into the puncture holes of the tires. It takes only a few minutes to make up for them. It is not durable enough, and the large wounds cannot be filled with shots.
3, paste fill
The paste needs to remove the tire and then affix a special tire rubber to the inner layer of the wound to complete the leakage. This is suitable for wounds. It is also not durable enough and needs to be repaired at the repair shop as soon as possible.
4, fire compensation


    The fire repair also needs to remove the tire, attach the special raw film to the wound, and bake the wound to the wound with a baking machine until the raw film and the tire are completely attached, but the technical requirements of the fire compensation are high, if the control is not good, The tires will deform or scorch. Small i suggested that it is best not to choose to make up.
How to prevent tires from getting stuck in traffic?

    1. Roads with rutting should follow the rut so that even if there are nails on the road, they may have been pulled away or pushed to the side of the road.
2. Try not to drive too far to the right on the roadside of the national highway or provincial road. Do not grind the road surface, especially the smashed tires of large trucks, which may contain steel wires.
3, driving through the repair shop to pay attention to, where the most screws.

The cooling parts is a vital components of diesel engine which can keep engine temperatures in our tractor under our control. The cooling parts of kubota which can be offered are radiator, water pump,thermostat,and fan.Most of them are for kubota engine 03 series,05 series. Any component of cooling parts is broken,please change them in time.Otherwise, it will cause the damage of engine when the temperature is out of control. Our quality of cooling parts can match the genuine quality and works well for the kubota engine.

Cooling Parts For Kubota

Cooling Parts For Kubota,Kubota Tractor Parts,Kubota Cooler Parts,Kubota Cooling Spare Parts

Hangzhou Holdwell Mechanical&Electrical Co.,LTD , http://www.dieselpart.nl